HUST CNC H6D-T - Page 208

UST CC 6-T Manual
4 - 32
Setting  3: Filtration freuency is 342 .
 hen setting the corresponding feedback filtration freuency according to the
Spindle ncoder setting, the System will be able to prevent the noise interference
effectively.
times multiple, then the Spindle can reach 5 RPM of maimum speed. ote:
34241245 RPM/6 sec
case, 5   1253/6.
The customer can set such parameter at moderate value according to the Spindle
ncoder installed for the machine and the reuired maimum Spindle speed.
127. Retention.
128. Set 1 Tooth ap Offset
Format  .
Scope: -.  . mm, which can be used to remove the reverse gap of the
stud.
 hen performing reverse action, certain gaps may eist in the stud. In this case,
such parameter can be used to make correction.
129. Ais Feedback irection Setting
Format  default value: 
Setting  , means the forward feedback direction.
Setting  1, means the reverse feedback direction.
It is mainly used to set the feedback direction of // aes in order to save the
trouble of line change.
parameter as “1” to avid confusing the feedback signal.
130. Feedback Filtration Freuency Setting
Format  default value: 
Setting  , means the Filtration Freuency is 5 
Setting  1, means the Filtration Freuency is 75 