HUST CNC H6D-T - Page 298

HUST CNC H6D-T Manual
7 - 30
Fig 7-2 D Homing Speed and Direction of finding GRID
MCM# 350~360 System Reserved
361. Setting the X-Home grid setting.
362. Setting the Y-Home grid setting.
363. Setting the Z-Home grid setting.
364. Setting the A-Home grid setting.
365. Setting the B-Home grid setting.
366. Setting the C-Home grid setting.
367. Setting the U-Home grid setting.
368. Setting the V-Home grid setting.
369. Setting the W-Home grid setting.
Format= . (Default=0.000), unit: mm
Leaving from the origin switch signal, deviating from the above set distance, and
then you can start to execute the Homing process (third section) to locate the
motor Gird signal.
MCM# 370~380 System Reserved
381. Home-Shift Data, X-axis.
382. Home-Shift Data, Y-axis.
383. Home-Shift Data, Z-axis.
384. Home-Shift Data, A-axis.
385. Home-Shift Data, B-axis.
386. Home-Shift Data, C-axis.
387. Home-Shift Data, U-axis.
388. Home-Shift Data, V-axis.
389. Home-Shift Data, W-axis.
Format . Unit: mm/min (Default=0.000)
Set the amount of coordinate shift for HOME location (or machine origin). With
these settings, the machine coordinate will be shifted by the same amount when
you execute "Home". If home shift data are zero for all axes, the machine
Speed MCM #136~ #139
Direction MCM#130~ #133
3
r
d
2
n
d
Tool Position
Speed
Touch the LIMIT SWITCH
C064=1 C065=1 C066=1
Leave the LIMIT SWITCH
C064=0 C065=0 C066=0
Speed MCM#136~ #139 1/4
Direction MCM#231~ #234= 0
INDEX of finding Encoder
Speed MCM#142~ #145
Direction MCM#231~ #234= 0
1
s
t
Section Speed