7 MCM Parameters
7 - 51
Segment length =100.00mm and the amount of compensation is 0.026mm as set
in MCM#861. Then, the compensation for each section is 0.026/8=0.00325mm.
The compensation for this segment will be done in a manner as tabulated below:
Section Tool Position
Avg. comp. For each
section
Actual comp. At each
section
Accumulated
compensation
1 12.5 0.00325 0.003 0.003
2 25 0.00325 0.003 0.006
3 37.5 0.00325 0.003 0.009
4 50 0.00325 0.004 0.013
5 62.5 0.00325 0.003 0.016
6 75 0.00325 0.003 0.019
7 87.5 0.00325 0.003 0.022
8 100 0.00325 0.004 0.026
MCM# 857~860 System Reserved
861~1340. Amount of Compensation for each segment (X.Y.Z.A.B.C-axis) is 80.
The Compensation value is in incremental mode. If the number of segment is less than
80, please fill the uncompensated segments with zero to avoid any potential errors.
Ex:
If the segment of compensation is 10, the amount of the compensation from Seg.11 to 40
( X-axis MCM#861~940, Y-axis MCM#941~1020, Z-axis MCM#1021~1100, A-axis MCM
#1101~1180, B-axis MCM#1181~1260, C-axis MCM#1261~1340 ) must be set as zero.
MCM#861~940 Pitch error compensation of each segment, X-axis.
MCM#941~1020 Pitch error compensation of each segment, Y-axis.
MCM#1021~1100 Pitch error compensation of each segment, Z-axis.
MCM#1101~1180 Pitch error compensation of each segment, A-axis.
MCM#1181~1260 Pitch error compensation of each segment, B-axis.
MCM#1261~1340 Pitch error compensation of each segment, C-axis.
Format . Unit: mm (Default=0.000)
1341. Tool#1, Radius Offset Data.
1342.X-axis Offset Data, Tool#1.
1343.Y-axis Offset Data, Tool#1.
1344.Z-axis Offset Data, Tool#1.
1345.A-axis Offset Data, Tool#1.
1346.B-axis Offset Data, Tool#1.
1347.C-axis Offset Data, Tool#1.
Format . Unit: mm (Default=0.000)
1348.Tool#2, Radius offset data.
1349.X-axis offset data, Tool#2.
1350.Y-axis offset data, Tool#2.
1351.Z-axis offset data, Tool#2.
1352.A-axis offset data, Tool#2.
1353.B-axis offset data, Tool#2.
To Next Page
Loading...