2 Operation
2 - 25
* Tool Radius
Press the Tool Radius key into this page.
Prerequisite: The axis must in the Home position that can into this page.
Page (1) :
Fig. 2-29
Note: When mount the Tool above the Workpiece, it means the Upper Holder
(Rear Holder); when mounting under the Workpiece, it means the Lower
Holder (Front Holder). The system parameters can be used to set the
Holder type, for example, X-Axis means the direction when Tool is
leaving the Workpiece (refer to Fig. 2-34). If the Tool is located at
“Negative X Direction” at the center of the Workpiece, then negative
value should be entered for the diameter (as per Example 2).
Tool Calibration Step:
1. Clamp the Workpiece securely (clamp with Pedal Switch or Manual Chuck key).
2. Set the group number.
3. Write in X-Axis position.
a. Move the Tool with Hand Wheel for accepting OD machining. Before the
entire Tool leaves the machining coordinates, press the “X Tool Offset” key
and at this time, the system will save the machine coordinates of X-Axis in
the X-Axis position.
b. Move the Tool away with Hand Wheel. After measuring the actual Workpiece
diameter, enter the diameter of X-Axis.
To Next Page
Loading...