HUST CNC H6D-T Manual
II
2.2.2 Program Editing 2-42
2.2.2.1 Creating a New Program 2-42
2.2.2.2 Editing a Program 2-43
2.2.2.3 Entering Fractions 2-48
2.2.2.4 Editing Notes 2-48
3 G/M Codes 3-1
3.1 Command codes 3-1
3.2 Positioning, G00 3-4
3.3 Linear Cutting, G01 3-5
3.4 G02, G03 Circular Interpolation 3-7
3.5 Dwell Command, G04 3-11
3.6 Parabolic Cutting, G05 3-12
3.7 Exact Stop Check, G09, G61, G62 3-15
3.8 Spindle Positioning Command, G15 3-16
3.9 Cylindrical Plane, G16 3-16
3.10 Plane setup, G17-G19 3-20
3.11 Automatic Reference Position Return, G28 3-23
3.12 Return From Reference Position, G29 3-24
3.13 2nd Reference Position Return, G30 3-25
3.14 Thread Cutting, G32 3-26
3.15 G33 Tapping Cutting Canned Cycle 3-30
3.16 G34 Variable Lead Thread Cutting 3-31
3.17 Canned Cycle Functions (For implication of programming) 3-36
3.17.1 Single Cutting Canned Cycle, G90, G92, G94 3-36
Longitudinal Cutting Fixed Cycle, G90 3-36
Outer/Inner Diameter Tapered Lateral Canned Cycle, G90 3-37
Thread Cutting Fixed Cycle, G92 3-38
Tapered Thread Cutting Canned Cycle, G92 3-39
Face Cutting Fixed Cycle, G94 3-40
Face Cutting Fixed Cycle, G94 3-41
3.17.2 Compound Canned Cycle Functions, G70~G76 3-42
Finishing Cycle, G70 3-43
Longitudinal Rough Cutting Cycle, G71 3-43
Face Rough Cutting Cycle, G72 3-47
Formed Material Rough Cutting Cycle, G73 3-50
To Next Page
Loading...