WINDOW CLEANING ROBOT
ATTACH THE CLEANING PAD
FILL IN CLEANING AGENT
CONNECT TO THE POWER
ATTACH THE SAFETY ROPE
NOTE & CAUTION
START CLEANING
QUICK START GUIDE
Attach a clean pad to the device. Make sure it is
smooth and tight.
Connect the adapter and the power plug as
shown in the sequence below. Finally, insert the
plug into the power socket.
Note: For heavily soiled windows, it is recom-
mended to spray some window cleaner on the
window before use. Replace the cleaning pad in
time once it gets dirty, and run the device the
second pass with the water spray off to remove
streaks, if any.
Caution!
Do not leave the device on the window longer
than necessary to avoid damage. Be sure to hold
the device tightly when you turn it off to avoid
accidental dropping.
When the cleaning process is finished, the device
returns to the starting point by itself.
Grasp the device and press the power button for 3
seconds until the device turns off.
Remove the unit from the glass, check the degree of
soiling of the pad and wheels, and clean them if
necessary before further use. Top up with water if
necessary.
To start the cleaning process, place the device in the
center of the window.
Press and hold the power button for 3 seconds to
turn on the device. Check that the device is securely
attached to the glass.
Briefly press the power button again to start the
cleaning process.
The safety rope is intended for use at high-rise
windows. Check the rope for damage before use.
Then attach it to a solid object.
Improper connection can
cause damage to the device.
Caution!
Open the pot of the water tank, fill in an appro-
priate amount of pure water or special glass
cleaner. If necessary, use the enclosed filling aid.
Close the water tank tightly again.
Press and hold
the power button for
more than 1 second
To Next Page
Need help?
General
