What to do if Huyosen CG430MF-3 engine starts but stops again?
If your Huyosen Pole Saw engine starts and then stops, it could be due to incorrect fuel type. In this case, empty the fuel tank and refill it with the correct fuel. Alternatively, a clogged air filter might be the cause, so try cleaning the air filter.
General| Power Type | Gasoline |
|---|---|
| Power Source | 2-Stroke Engine |
| Engine Displacement | 42.7 cc |
| Chain Pitch | 3/8 inch |
| Chain Gauge | 0.050 inch |
| Bar Length | 10 inches |
Specifies the product's primary function for cutting branches and twigs.
Illustrates and labels the main components of the gas pole saw.
Explains critical safety symbols including general warnings, PPE, and manual reference.
Symbols related to oil flow adjustment, chain direction, primer bulb, choke, and noise emission.
Details safety distances for high-voltage lines and general bystander safety zones.
Defines terms like WARNING, CAUTION, and NOTE used throughout the manual.
Provides fundamental safety rules for operating the product.
Critical safety precautions to follow during the assembly process.
Essential safety guidelines to observe while using the pole saw.
Guidance on selecting and using appropriate protective gear for safe operation.
Instructions for regularly checking and ensuring safety devices are functional.
Procedure to verify the correct operation of the throttle trigger lockout mechanism.
Step-by-step guide for attaching the guide bar and saw chain to the unit.
Instructions for securely attaching the front handle to the pole shaft.
Steps for connecting the modular sections of the pole shaft.
Guide on how to correctly put on and adjust the operator's safety harness.
Instructions for securely connecting the pole saw unit to the harness system.
Explanation of the quick-release mechanism on the harness buckle for emergencies.
Details on the specific type of gasoline and two-stroke oil required for the engine.
Precise instructions and ratios for creating the correct fuel-oil mixture.
Safe procedures and precautions for filling the fuel tank.
Guidance on selecting and using the appropriate chain oil for lubrication.
Best practices for operating the pole saw effectively and safely during cutting.
Step-by-step guide for starting the engine when it is cold.
Critical warning regarding throttle control use when starting a cold engine.
Instructions for safely shutting down the engine.
Step-by-step guide for starting the engine when it is already warm.
Warning about potential burn injuries from hot engine parts and electrical shock risks.
A schedule detailing daily, weekly, and monthly maintenance tasks for the product.
Procedure for setting the correct engine idle speed for optimal performance.
Guidance for performing maintenance tasks specifically on the trimmer head.
Steps for inspecting the spark plug's condition and ensuring proper ignition.
Instructions for cleaning the air filter to prevent engine issues.
Detailed guide on proper techniques, angles, and tools for sharpening chain cutters.
Common causes and solutions for when the engine fails to ignite.
Troubleshooting steps for issues where the engine starts but then shuts off unexpectedly.
A comprehensive table listing common problems, their causes, and resolution procedures.
To Next Page