MP34.7002
16MAR10
OPERATING PROCEDURES
DUAL DIRECTION STORAGE SLIDE OUT OPERATION
The HWH SLIDE OUT is operated by toggle switches inside
the compartment doors. There is a switch on the driver’s
side and passenger’s side of the compartment.
The park brake must be set to use the STORAGE
SLIDE OUT. The system control module and the
vehicle ignition do not have to be on.
extend the storage slide out.
NOTE: Make sure there is adequate clearance to fully
WARNING:
CLEAR OF THE STORAGE SLIDE OUT WHEN OPERATING.
KEEP PEOPLE AND OBSTRUCTIONS
The passenger side control toggle switch must be used to
extend the storage slide out the passenger’s side. The
driver side control toggle switch must be used to extend
the storage slide out the driver’s side.
If the storage slide is extended (either side) either control
switch can be used to retract the storage slide.
EXAMPLE 1: The storage slide is extended out the
passenger side of the vehicle. Push and hold the driver’s
side control switch to "RETRACT". The storage slide will
move to the retracted position and stop.
EXAMPLE 2: The storage slide is extended out the
passenger side of the vehicle. Push and hold the driver’s
side control switch to "EXTEND". The storage slide will
retract into the vehicle then extend out the driver’s side
as long as the control switch is held to the extend position.
IMPORTANT: DO NOT hold the control switch in the
"EXTEND" or "RETRACT" position more than 10
seconds after the storage slide is fully extended,
retracted or stops moving. DO NOT FORCE THE
STORAGE SLIDE.
To Next Page
Loading...
