1
TABLE OF CONTENTS
WEEE AND THE BATTERY DIRECTIVE 2
INTRODUCTION 3
UNPACKING 3
INSTALLING THE SOFTWARE 4
INSTALLATION AND SITE HARDWARE DIAGNOSTICS TOOL (IDT) 5
READING THE LOGGER 5
CONFIGURING THE LOGGER 7
Enhanced Recordings 12
Data Communications Confirmation – GPRS Test 14
Troubleshooting a GPRS test failure. 15
Antenna installation considerations 16
Installation Process Decision Tree 17
Locating in plastic lidded chambers 22
Adding an External Battery Pack 25
Installing your logger at site 26
Connecting the flow cable 27
Connecting the sensors - Pressure 28
Taking a reading from the logger and hardware diagnostics 29
Final site commissioning checks 31
Installation checklist 33
USING HWM DATAGATE™ 34
Setting up DataGate™ Alarm Recipients 38
Setting up channel settings (optional) 40
USING HWMONLINE™ 41
Viewing your data 41
Viewing information about your logger fleet 43
Technical Specifications 44
APPENDIX – ADDITIONAL INFORMATION 49
Pulsers 49
Meters & Pulse Value Guide 51
Fitting your own SIM card 54
To Next Page
Loading...