6
English
Heater for external canister lters
HEATER is the rst aquarium heater that works outside of the aquarium tank. We would like to congratulate you on choosing HEATER, and invite you to
read the following instructions carefully, to better understand the characteristics that make HEATER a unique product.
Description
A. Tube connector
B. HEATER hanging eyelet
C. Water ow indicator
D. Temperature control knob
Installation
Caution: Before placing your hands in the tank, disconnect all electrical appliances. Be sure that the voltage of the mains corresponds to the voltage shown on the heater label.
HEATER must be installed outside of your tank by cutting the outlet tube of the external lter, and by connecting the two parts of the tube onto both sides of the HEATER -g.
2-. If the external lter is already installed, it is important to shut o the valve taps, to empty out all the water that it contains, before cutting the outlet tube. The presence of
air bubbles inside the heating unit can cause irreversible damages. Make sure that HEATER is installed in a vertical position and follow the ow direction of the water that is
indicated on the heater’s body with an arrow. -g. 3- Reactivate the aquarium’s water circulation and connect the new heating system to the mains. After the rst 24 hours of
operation it is advisable to check all connections are tight.
Temperature setting
To set the required temperature in your aquarium, turn the temperature control knob (D) until the indicator on the heater’s body shows the chosen value on the scale -g. 4-.
You can set the temperature required between 18°C and 34°C (65°F - 93°F). Should the water temperature of your aquarium turn out to be lower than the value set on the
graduated scale, HEATER will start heating automatically and the indicator will turn on.
To Next Page
