To Next Page
P
Peter CollinsAug 15, 2025
Why is the light blinking when operating my Hydrogen For Health PEM+ Medical Equipment?
- RRaven OconnorAug 15, 2025
The blinking light indicates a low battery. You should charge the unit as soon as possible.
Why is the light blinking when operating my Hydrogen For Health PEM+ Medical Equipment?
The blinking light indicates a low battery. You should charge the unit as soon as possible.
What to do if my Hydrogen For Health Medical Equipment bottle isn't making hydrogen?
If your bottle isn't producing hydrogen, try the following: first, ensure the battery is charged. Second, inspect the power cord and replace it if necessary. Finally, the membrane may be dry; reactivate it by adding 1 inch of water to the bottle and letting it sit for 24 hours.
What to do if my Hydrogen For Health PEM+ Medical Equipment bottle is leaking?
If your bottle is leaking, check the silicone seal between the upper container and the base for any damage. Also, make sure the upper container is tightly screwed onto the base.
What to do if my Hydrogen For Health PEM+ Medical Equipment bottle is making large bubbles?
If your bottle is producing large bubbles, remove the silicone shipping plug from the electrolysis plate. Also, the membrane may be dry, so try reactivating it. Note that these large bubbles are hydrogen, not oxygen.
How to fix Hydrogen For Health Medical Equipment bottle that won't charge?
If your bottle won't charge, replace or try a different power cord.
What does it mean if the power button blinks red on my Hydrogen For Health PEM+ Medical Equipment?
If the power button blinks red three times and stops when you plug in the power cord, it may indicate that you need a new battery. Contact us for repair.
Why are PPM levels low when testing my Hydrogen For Health PEM+ with Blue Drops?
If you're experiencing low PPM levels when testing with Blue Drops, allow 7 days for the unit to break-in. Also, try operating the unit more times to activate the PEM membrane.
Why is there water in my new Hydrogen For Health PEM+ Medical Equipment generator?
The product is shipped wet to keep the membrane moist.
Why isn't my Hydrogen For Health Medical Equipment bottle making waste water?
It's perfectly normal if your bottle isn't producing waste water. This indicates that the bottle is adequately controlling pressure.
Recommends quality drinking water and warns against carbonated liquids.
Instructs to saturate the PEM membrane with water for 4-5 hours before initial use.
Guidance on storing hydrogen water, cleaning, and avoiding immersion or direct sunlight.
Instructions for obtaining warranty service through authorized channels.
Visual identification of all components of the hydrogen rich water bottle.
Steps for initial setup, including removing the shipping plug and saturating the membrane.
Details on charging the bottle, operating modes (5/7 min cycles), and indicator lights.
How to drink the water, manage waste water, and understand gas release.
Step-by-step guide on how to attach suitable adapters to the bottle.
Key technical specifications including power, volume, concentration, and materials.
Guidance on daily cleaning, periodic cleaning with citric acid, and odor treatment.
Addresses common problems like no hydrogen production, charging issues, leaks, and bubbles.
General| Brand | Hydrogen For Health |
|---|---|
| Model | PEM+ |
| Category | Medical Equipment |
| Language | English |