Need help?Do you have a question about the Hydronic IPG315D and is the answer not in the manual?
Displays unit status, current date, and temperatures like return/leaving water or ambient.
Details the keypad layout and how information is organized into menus and sub-sections.
Provides direct links to specific functions, accessible via quick dial keys on the main screen.
Displays configured sensors' values and circuit-specific refrigerant variables.
Allows editing of water set-points and displays status of energy saving and dynamic set point functions.
Details how alarms are displayed, their statuses (Active, Resettable, Password), and reset procedures.
Monitors compressor status, unloading steps, and condensation/evaporation pressures for each circuit.
Allows modification of various parameters based on the selected user access level.
Configures time, date, and scheduling for Energy Saving and Auto On/Off functions.
Displays compressor working hours and start-up counts, with options for reset and maintenance.
Displays water pump working hours and allows for maintenance enable/disable and hour reset.
Records and displays all alarms with event date and unit status for historical review.
Checks the working status of the defrost cycle for each refrigerant circuit.
Checks the physical status of all inputs and the logical status of all outputs defined in the controller.
Displays the working status of configured electronic expansion valves, including temperature, pressure, and opening percentage.
Checks the status of the "Recovery" function and heat recovery circuit operation.
Checks the status of the "Free-Cooling" function, probes, and settings.
Monitors discharge temperatures and settings related to liquid injection and high discharge temperature alarms for compressors.
Checks the status of the "Domestic hot water" function and its relevant probes and settings.
Manages parameter files, contrast, backlight, and other control panel settings.
Displays unit status and probe values using LEDs on the interface.
Explains the keypad layout and navigation for accessing menus and functions on the LED interface.
Allows editing of water set-points via the LED interface.
Provides access to various service sub-menus via the LED interface's MENU button.
Enables user level selection and access to parameter programming on the LED interface.
Allows reading and resetting alarm codes and their statuses on the LED interface.
Displays and details alarms from the history log, including event number, date, and unit status.
Enables/disables compressors for maintenance and displays start-up numbers.
Views and resets the start-up numbers for each configured compressor.
Enables/disables water pumps for maintenance.
Views and resets working hours for compressors and water pumps.
Shows the working status of condensing or evaporating fans on air-cooled units.
Shows the working status of the defrost cycle, visible only on heat pumps during heating.
Displays the status of controller inputs and outputs, categorized into groups.
Shows the working status of expansion valves, including opening percentage and superheat.
Loads parameters from configuration files, managing actual and default settings.
Downloads unit, alarm, XEV, and access log files to USB storage.
Displays system information like software application name, Modbus address, and IP address.
General| Model Number | IPG315D |
|---|---|
| Category | Heat Pump |
| Heating Capacity | 15 kW |
| Power Supply | 400V, 3Ph, 50Hz |
| Refrigerant | R410A |
| Operating Temperature Range (Cooling) | 10°C to 43°C |
To Next Page