Need help?Do you have a question about the Hydrotec HY-MAG INTEGRAL Series and is the answer not in the manual?
Introduces the HY-MAG Integral control box and its capabilities for water conditioning units.
Lists key technical data such as mains voltage, protection class, and operating temperatures.
Provides important notes on IP65 protection, cover operation, and thermal protection for DN100.
Details the connection procedure using Harting plugs for DN25 to DN65 HY-MAG units.
Explains the connection process for the DN100, including thermal protection cable.
Describes the automatic initiation and system check sequence upon power-up.
Details the LCD display readings for control box, short-circuit, and operational tests.
Explains the LED patterns indicating operation phases, including GREEN and RED states.
Details the REFIT phase for magnetic remanence clearing and its LED indications.
Explains the use of front foil buttons (Menu, Clear, Up, Down) for menu navigation and parameter setting.
Describes how to access the main menu to select individual sub-menus.
Details the HY-MAG operation on a continuous 24-hour/day basis.
Explains the standby mode operation controlled by internal timers for switch-on/off times.
Explains the two counters for absolute and relative operating hours and how to reset them.
Details how to alter the internal timer and date settings via the menu.
Describes setting switch-on/off times for groups of days (e.g., Mon-Sun, Mon-Fri).
Explains how to set specific switch-on/off times for each individual day of the week.
Details how to select the operating language from the available options.
Explains that the service menu is code-protected and intended for authorized personnel only.
Describes how failures are indicated via LED-scale, display, and potential-free contact.
Lists and describes common failure codes (e.g., Undercurrent, Overload, Short cut) and their probable causes.
Provides initial checks for no display or operation, including fuse checks.
Outlines steps for undercurrent (connection) and overload (coil failure) issues.
Describes actions for short circuits and faulty control box components.
Explains the thermal safety control release for the DN100 due to coil overheating.
Advises checking external influences or water stagnation and verifying cooling.
General| Brand | Hydrotec |
|---|---|
| Model | HY-MAG INTEGRAL Series |
| Category | Water System |
| Language | English |
To Next Page