How to fix a Hydrotek Active Aqua 1/10 HP Chiller when the unit doesn’t run and the display is blank?
If your Hydrotek Chiller unit doesn’t run and the display is blank, first, ensure that the power is turned on. Also, check that the power cord is fully plugged in.
What to do if the Hydrotek Active Aqua 1/10 HP performance is decreased or there is no refrigeration?
If the performance of your Hydrotek Chiller is decreased, or there is no refrigeration, it may be due to several reasons. First, make sure that the set temperature is not higher than the aquarium water temperature by resetting the temperature. Second, the air inlet or outlet might be clogged, in that case clean them with a brush or a vacuum cleaner. If the fan is not working, return it to the place of purchase.
Why does my Hydrotek Chiller keep cycling on and off?
If your Hydrotek Chiller unit cycles on and off, it could be due to the wrong voltage or frequency, so apply the correct power source. It's also possible that the chiller is in protection mode. In this case, check if the water circulation is normal and if the fan and the chiller dissipate heat normally. After checking, wait for 3 minutes, and the unit will automatically turn on again.
How to fix loud operation of Hydrotek Active Aqua 1/10 HP Chiller?
If your Hydrotek Chiller is operating loudly, it might not be installed on a flat surface. Reinstall it correctly to resolve this issue.
General| Horsepower | 1/10 HP |
|---|---|
| Voltage | 115V |
| Frequency | 60 Hz |
| Refrigerant | R134a |
| Temperature Range | 39-90°F |
To Next Page