1.
HWFII-4
GENERAL DESCRIPTION
The Kickspace wall kits have been designed to accommodate a Hydrotherm Kickspace Model HK42, HK84, or HK120
Kickspace heater to deliver a comfortable stream of warmed air through the wall by a unit mounted in the wall, or on the
surface of the wall. Kits consist of front grille panels, back panel, and necessary mounting hardware. The Kickspace heater
is sold separately.
The recessed (HW kits) cabinet for the HW42 will fi t between 16" center studs. The HW84/HW120 will require a small
amount of framing to suit the mounting.
Installation instructions should be read thoroughly IN CONJUNCTION WITH INSTALLATION INSTRUCTIONS AND
WIRING DIAGRAM SUPPLIED WITH KICKSPACE HEATER UNITS, prior to starting installation.
WARNING: DISCONNECT POWER BEFORE SERVICING UNIT,
POTENTIAL ELECTRICAL SHOCK HAZARD!
ATTENTION: READ THESE INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO INSTALL, OPERATE, OR
SERVICE THE HYDROTHERM KICKSPACE HEATERS! RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
INSPECT THE SHIPMENT IMMEDIATELY WHEN RECEIVED TO DETERMINE IF ANY DAMAGE HAS OCCURRED
DURING SHIPMENT.
PRIOR TO INSTALL, CHECK FOR ANY VISIBLE DAMAGE.
2/12
RECESSED AND SURFACE MOUNT WALL KITS
RECESSED "HW" / SURFACE MOUNT "HF" WALL KIT
To be used in conjunction with Kickspace Heater • Type HK
Kickspace Heater Installation Instructions
For use with HK42/HK84/HK120 Kickspace Heaters
KICKSPACE HEATER
INSTALLATION INSTRUCTIONS • TYPES HW & HF
260 NORTH ELM STREET, WESTFIELD, MASSACHUSETTS 01085
www.hydrotherm.com
To Next Page
Need help?
General