HYLA GST - Blowing Function and Post-Use Care

1.
2.
34 Blowing
BLOWING AFTER EACH USE
After Each Use 35
• Remove exhaust grid on Motor Unit Assembly.
• For full power while blowing, switch on the HYLA, connect the Flexible Hose to the front
connector rst and then connect the hose to the exhaust.
• Do not turn off HYLA while switching the Flexible Hose from the front to the back.
1. Turn off the main switch and disconnect the power
cord from the power source.
2. Empty the Water Pan Assembly immediately after use
and rinse with clean water.
3. Wipe the underside of the Motor Unit Assembly using
a wet cloth. Do not rinse the Motor Unit Assembly
with water!
4. It is important to store the HYLA System with the
handle in the opposite position, which will allow
it to dry after use.
WARNINGS
• Disconnect the power cord from the
power source before removing the motor
unit assembly from the water pan!
• DO NOT use the system without water!
• The HYLA GST Air and Room Cleaning System
is not designed for picking up larger quantities
of mineral dust!
• DO NOT vacuum ammable liquids!