P A G E
19
ADJUSTMENT
BMX Scooter
ASSEMBLY
Brake Lever Cable Installation
1)
Tighten adjuster all the way into lever. Slide the cable end up into the
cable end slot. Run the cable into the cable slot through the adjuster slot
until cable is seated in adjuster.
Turn adjuster slightly counter clockwise so adjuster slot is not aligned
with the cable slot. This keeps the brake cable attached to the lever.
Squeeze and releasing the lever to test if the brake cable is securely in
installed on the brake lever.
2)
3)
Brake Cable
Installation
ADJUSTER
CABLE END
CABLE
LEVER
CABLE END SLOT CABLE SLOT
To Next Page
Loading...