Hypertec Power-Mate Lite - Specifications; Overload

OVERLOAD
When the current exceeds 10A, the display ashes the message “WARNING, OVER/LOAD”, disconnect the
excessive load as soon as possible to avoid overloading and damaging the Power- Mate.
SPECIFICATIONS
NOTE: This unit is intended for operation @ 240Volts AC with a maximum load current of 10Amps.
Accuracy error for all ranges is below 2%, (typical accuracy is below 1%)
Note 1 : The VA and Power Factor accuracy is as specied when measuring above 2W.
Note 2 : Where the display shows more digits than the resolution specied, the accuracy
of any extra displayed digits is not guaranteed.
Legend Performance Technology PTY LTD
Customer Care: 1800 328 200
Internet: www.legend.com.au
Email: sales@legend.com.au
Setting Range
Units
Resolution Units
Rate Setting 0 – 99.999 c/kWh
G/Gas Setting 0 – 9.999
kg/kWh
Inbuilt Timer 1, 8, 12, 24
Hours
2, 5, 7, 14, 28 Days
Cost 0 – 999999
± $
0.01 c
Energy 0 – 99999
± kWh
0.01 kWh
G-Gas 0 – 99999
± kg
0.01 g
Volts 170.0 – 270.0
RMS
0.1 V
Amps 00.000 – 10.000
RMS
0.001 A
Power 0 – 2,400.0 ± W 0.1 W
Apparent Power 0 – 2,400.0 VA 0.5 W
Power Factor ± 0.001 to 1 (dimensionless) Leading/Lagging
Frequency 45-65 Hz 0.1 Hz
Run-Time measurement 99:23:59:59 Days:Hours:Min.:Sec.
V
A