Hypnocube 4Cube Instructions v 6.5, December 2013
- 45 -
Figure 74: Power switch mounted in place (ignore the power jack since that’s no longer used.)
Next attach the remaining two switches to the case. To be consistent with our other documentation, you should
place the switch labeled “BTN1” on the PCB in the middle, and the switch labeled “BTN2” in the remaining
spot, as shown in Figure 75. Secure the switches with the proper nuts. We recommend these switches be up in
the rest position so they are easy to press, but you can of course orient them any way you please.
To Next Page
Loading...