Hytera PD708 User Manual

Other manuals for Hytera PD708

Quick Reference Guide6 pages

• K

  Karen HarperAug 7, 2025

  What to do if the voice is weak during receiving on Hytera Portable Radio?

  

  Same questionReply

  • J

    Jennifer LeAug 7, 2025

    If you are experiencing weak, discontinuous, or inactive voice during receiving on your Hytera Portable Radio, first try recharging or replacing the battery, as the battery power may be too low. Also, ensure the volume isn't set too low by increasing it. Check the antenna; if it's loose, power off the radio and reinstall the antenna. Finally, inspect the speaker for blockages and clean the surface. If the problem persists after these steps, further assistance may be needed.

    

    Reply
• B

  Brian ChapmanAug 12, 2025

  How to fix power-on failure on Hytera PD708?

  

  Same questionReply

  • G

    griffinamberAug 12, 2025

    If your Hytera Portable Radio is experiencing power-on failure, start by removing the battery and reattaching it to ensure it's properly installed. If that doesn't work, the battery may be drained, so recharge or replace it. Also, inspect the battery contacts for dirt or damage; clean them if necessary. If the radio still won't power on after these steps, it may require professional inspection.

    

    Reply
• E

  Elizabeth YoungAug 17, 2025

  Why is there noise on the channel of my Hytera PD708 Portable Radio?

  

  Same questionReply

  • J

    Joshua FranklinAug 17, 2025

    If you are experiencing irrelevant communication or noise on the channel with your Hytera Portable Radio, it may be due to interference from other radios using the same frequency. Try changing the frequency or adjusting the squelch level. Alternatively, the radio may be set with no signaling. In this case, set signaling for all member radios to avoid interference at the same frequency.

    

    Reply
• J

  john65Aug 22, 2025

  What to do if I cannot communicate with other members on Hytera PD708 Portable Radio?

  

  Same questionReply

  • M

    Martin PhillipsAug 22, 2025

    If you cannot communicate with other members using your Hytera Portable Radio, first ensure that your TX/RX frequency and signaling are set to the same as those of the other members. Also, verify that all members are on the same channel type, either digital or analog. Finally, you may be too far away from the group; try moving closer to the other members.

    

    Reply
• B

  Barbara LopezAug 27, 2025

  Why is the noise too loud on my Hytera PD708?

  

  Same questionReply

  • N

    Nichole MillerAug 27, 2025

    If the noise is too loud on your Hytera Portable Radio, it could be because you are too far away from other members; try moving closer. Also, your position might be unfavorable, such as being blocked by buildings or in an underground area; move to an open and flat area and restart the radio. External disturbances like electromagnetic interference can also cause loud noise; move away from equipment that may be causing interference.

    

    Reply

Hytera PD708 Specifications

General

Channel Capacity	1024
Zone Capacity	16
Channel Spacing	12.5/20/25 kHz
Shock & Vibration	MIL-STD-810 C/D/E/F/G
Audio Output Power	1 W
Channels	1024
Frequency Range	136-174 MHz
Operating Voltage	7.4 V
Battery	Li-Ion 2000 mAh
Battery Life (5-5-90 Duty Cycle)	16 hours
Keypad	16 keys
Operating Temperature	-30°C to +60°C
Storage Temperature	-40°C ~ +85°C
Dust & Water Intrusion	IP67
Humidity	Up to 95% (non-condensing)
RF Power Output	UHF: 4W; VHF: 5W

Related product manuals

Hytera PD702

17 pages

Hytera PD705

27 pages

Hytera PD706

17 pages

Hytera PD706G

17 pages

Hytera PD708G

17 pages

Hytera PD705LT

17 pages

Hytera PD78X

42 pages

Hytera PD785

41 pages

Hytera PD782i

17 pages

Hytera PD795 Ex

31 pages

Hytera PD78X Series

182 pages

Hytera PD79 Ex Series

31 pages