00-2
GENERAL INFORMATION
HOW TO USE THIS MANUAL
This manual is divided into 23 sections. This first page of each
section is marked with a black tab at the edge of the page. You can
quickly find the first page of each section without looking through
a full table of contents.
Each section includes the essential removal, installation, adjust-
ment and maintenance procedures for servicing all body styles.
This information is current as of time of publication.
An INDEX is provided on the first page of each section to guide you
to the item to be replaced.
TROUBLESHOOTING tables are included for each system to help
you diagnose the system problem and find the cause. The repair for
each possible cause is referenced in the remedy column to quickly
lead you to the solution.
DEFINITION OF TERMS
Standard Value
Indicates the value use as the standard for judging the quality of
a part or assembly on inspection or the value to which the part
or assembly is corrected and adjusted. It is given by a tolerance.
Limit
Shows the standard for judging the quality of a part or assembly on
inspection and means the maximum or minimum value within which
the part or assembly must be kept functionally or in strength. It is
a value established outside the range of standard value.
NOTE, WARNING AND CAUTION
NOTE
A point of information.
WARNING
Information about an activity that could cause damage to the
vehicle.
CAUTION
Information about an activity that could cause injury or
damage to the driver, occupants or repair personnel.
ABBREVIATIONS
MPI: Indicates Multi Point Fuel Injection system.
FBC: Indicates Feedback Carburetor system.
To Next Page
Loading...
Need help?
General
