6
DO-IT-YOURSELF MAINTENANCE
27
G350B01HR-GAT
BLEEDING THE FUEL SYSTEM
The fuel system should be bled to
remove air as described in the illustra-
tion if the fuel supply is exhausted
during travel, when the fuel filter is
replaced, or if the vehicle is not used for
a long time.
1. Loosen the air plug at the upper part
of the fuel filter.
NOTE:
The fuel filter is located under the
driver's seat. To bleed the fuel sys-
tem, first tilt the driver's seatback
forward. (Refer to "To Inspect the
Engine Compartment Under the
Driver's Seat." on page 1-12.)
HHR4046
2. Pump the hand pump until there are
no more bubbles in the fuel coming
out of the air plug. When doing this,
place a cloth around the air plug to
prevent the escaping fuel from spew-
ing about.
3. Tighten the air plug when there are no
more bubbles in the fuel.
4. Continue pumping until the hand
pump becomes stiff.
5. Finally, check to be sure that there is
no leakage of fuel.
If in doubt, consult your nearest au-
thorized HYUNDAI dealer.
HHR4047
FUEL FILTER
G240A01A-AAT
POWER STEERING HOSES
It is suggested that you check the
power steering hose connections for
fluid leakage at regular intervals. The
power steering hoses should be re-
placed if there is severe surface crack-
ing, scuffing or worn spots. Deteriora-
tion of the hose could cause prema-
ture failure.
It is due to a power steering fluid
characteristic in extremely cold con-
ditions.
Recommended Fluid
Use PSF-3 type fluid
NOTE:
Do not start the engine when the
power steering oil reservoir is
empty.
To Next Page
Loading...
Need help?
General
