• AEB mode controls the disk clearance of the transmission, automatically.
• To start AEB setting, press AEB bar (or ) for 3 seconds.
• If you press or ESC, AEB setting will be canceled. Machine need to restart.
• If "OK" in actual gear window, press to complete AEB setting.
• Display during AEB mode
Symbol Meaning
ST Start AEB
K1~K4, KV, KR Calibrating clutch K1~K4, KV or KR respectively
OK
*
Calibration for all clutches finished
Spanner and Kx
*
Kx couldn't be calibrated, AEB finished
△E Engine speed too low
- Raise engine speed
▽E Engine speed too high
- Lower engine speed
△T Transmission oil temperature too low
- Heat up transmission
▽T Transmission oil temperature too high
- Cool down transmission
FO
*
Output speed not zero
FN
*
Shift lever not in neutral position
FP
*
Parking brake not applied
*
: Transmission stays in neutral, you have to restart the TCU (starting switch off/on).
Engine auto shutdown mode
• The engine auto shutdown function can be activated or cancelled.
• If machine is idling for the setting time (2~40 minutes), then engine will be shutdown automatically.
3-31
To Next Page
