REMOTE START QUICK REFERENCE GUIDE
Using the Remote Start Function
Using Valet/Service Mode
Service mode is used when servicing the vehicle to prevent the system from unexpectedly
starting the engine while being serviced. While in service mode, the system’s keyless entry
functions will operate normally, but the security system will not arm and the remote start function
is temporarily disabled. The system will honk the horn 2 times if an attempt is made to
activate the remote start system.
To Engage Valet/Service Mode; turn the ignition key to the ON or RUN position and press and
hold the button for 2 seconds on the remote control transmitter.
To Exit Valet/Service Mode (Return the system to its normal operating mode); turn the
ignition key to the ON or RUN position and press and hold the button for 2 seconds on the
remote control transmitter.
Important Note: When taking your vehicle to the dealer for service, it is recommended that you
inform the service personnel that your vehicle is equipped with a remote control start system.
Press to DISARM Security System
and unlock Driver’s Door. Press
again Within 5 Seconds to Unlock
All Doors and the Tailgate.
Press and Hold to Open the Trunk /
Hatch / Tailgate Glass, if Equipped
Press for Progressive CarFind
x1= 5 Soft Chirps
x2= 5 Louder Chirps
x3= 5 Full Volume Chirps
Press and Hold for Personal
Protection Alarm
Press to Arm the Security
System and Lock the Doors.
Vehicle entrances are protected
10 seconds after arming the
security system.
Press then to activate
Remote Start. Press again to
turn on rear defroster after remote
started if equipped.
To Next Page
Need help?
General
