6- 26 DO-IT-YOURSELF MAINTENANCE
Replacement instructions:
1. Allow the bulb to cool. Wear eye
protection.
2. Always grasp the bulb by its plastic
base, avoid touching the glass.
G260A01L-GAT
REPLACEMENT OF LIGHT
BULBS
Before attempting to replace a light
bulb, be sure the switch is turned to
the "OFF" position.
The next paragraph shows how to
reach the light bulbs so they may be
changed. Be sure to replace the
burned-out bulb with one of the same
number and wattage rating.
See page 6-33 for the wattage de-
scriptions.
G270A03L
G270A01L-GAT
HEADLIGHT AND FRONT TURN
SIGNAL LIGHT
High beam
Low beam
Turn signal light
!
CAUTION:
o Keep the lights out of contact
with petroleum products, such
as oil, gasoline, etc.
o Be sure to replace the LED type
equipped bulbs with assembly.
1. Adjust headlights so that main axis
of light is parallel to center line of
the body and is aligned with point
"P" shown in the illustration.
2. Dotted lines in the illustration show
the center of headlights.
SPECIFICATIONS:
"H"
Horizontal center line of headlights
from ground
General type: 634 mm (24.96 in.)
HID type: 628 mm (24.72 in.)
"W"
Distance between each headlight
center: 1,240 mm (48.8 in.)
"L"
Distance between the headlights
and the wall that the lights are
tested against : 3,000 mm (118.11
in.)
To Next Page
Loading...
Need help?
General
