To Next PageTo Next Page
Need help?Do you have a question about the I.B.O.S. CamBoss and is the answer not in the manual?
General| Brand | I.B.O.S. |
|---|---|
| Model | CamBoss |
| Category | Analytical Instruments |
| Language | English |
Explains various safety symbols and their meanings to prevent hazards connected with injury or damage.
Critical instructions for electrical safety, preventing liquid ingress, and maintenance procedures.
Describes the variants and functions of the CamBoss control unit, including its panel and computer capabilities.
Details the standard KZ90 head with optical zoom, LEDs, and optional lasers for measuring cracks.
Describes the KZ75CB head with electronic position sensing, manual focus, and LED lighting.
Details the BOSS150 crawler for DN150-DN1200 pipes, including sensors, speed, and chassis options.
Describes the BOSS100 crawler for DN100-DN300 pipes, including drive, sensors, and speed.
Covers cable drum variants, capacity up to 500m, and 'Smart Feed' synchronization technology.
Describes the pantograph for DN200+ pipes with integrated LED light and electronic control.
Details the R250 axial camera with image stabilization, LEDs, and compatibility with control units.
Outlines initial operation, training, and component selection for different pipe diameters.
Guides through turning on the system, testing functions, and selecting actual wheel size before crawler operation.
Describes the procedure and safety precautions for lowering the crawler into a shaft using a special holder.
Explains how to control camera rotation, pan, zoom, focus, return to zero position, and use laser measurement.
Details crawler movement using the left joystick, cruise control activation, and speed fine correction.
Describes controlling the pantograph lift for camera height and adjusting additional lighting intensity.
Guides through menu navigation for selecting components (Case) and configuring system settings.
Covers settings like low pressure protection, camera current, decimal places, and camera head calibration.
Details activating the computer, hard restart procedures, and using software for inspection reports.
Cleaning procedures for all parts, wheels, and avoiding pressurized water on cameras.
Instructions for cleaning, lubricating, and securing the winding mechanism and trapezoidal screw.
Guidance on fuse replacement, troubleshooting common system issues, and contacting customer service.
