8.The scanner must be checked for
square, prior to installing the
mounting hardware at the top of the
overhead.
9.Hook a tape-measure on bottom
rear edge of scanner, as shown.
10.Run the tape diagonally to the
upper open corner, as shown and
record the measurement.
Measurement should be
approximately 65-3/8” [166cm].
11.Take the same measurement on
the opposite corners and record
measurement.
The two measurements must be
identical + 1/16” [1.6mm]. If
measurements are not within
tolerance, push the top of the
scanner to the right or left and re-
measure.
To Next Page
Loading...
