ENG
IACER Srl 8 MNPG314-00
Measurement
BODY TEMPERATURE
• Press measurement button to turn on
thermometer and it displays boot screen (fig. 9.1).
After POST and two beeps, it will display value of
room temperature and be ready for measurement
(fig. 9.2).
• Make sure the thermometer is under body mode.
• Keep distance at less than 5cm from upper
eyebrows to the probe (fig. 9.3). Press
measurement button and when it gives a “beep”
measurement value is exceeding alarm value
(Defaulted value is 38°C), it will give 3 beeps as an
indication.
• After measurement, if the thermometer is idle in
20 seconds, it will display “OFF” (fig. 9.5) and gives
a beep and shut off automatically.
To Next Page
Loading...