13
Never run the dishwasher without the filters in place. When cleaning the filters, don't knock on
them. Otherwise, the filters could be distorted and the performance of dishwasher could be
compromised .
3
If do it from step1 to step 3, the filter system will be removed; while if do it from step3 to step 1, the filter system
will be installed.
NOTE：
1
2
It is necessary to clean the spray arms regularly, as hard water chemicals and
food remnants can clog the spray arm jets and bearings. To remove the spray
arms,
to take out the washer on top of the spray arm and remove the arm. Wash
the arms in soapy and warm water and use a soft brush to clean the jets. Replace
them after rinsing them thoroughly.
Please confirm this is the correct removal method, if not make appropriate
change
Cleaning the Spray Arms
Step１：turn the filter cylinder counter-clockwise,
then lift it up
Step２：lift the Main filter up
Step 3： lift the Fine filter up
It is necessary to clean the spray arms regularly , hard water chemicals
clog the spray arm jets and bearings. To remove the spray arm,
screw off the nut clockwise to take out the washer on top of the spray arm and
remove the arm. Wash the arms in soapy and warm water and use a soft brush
to clean the jets. Replace them after rinsing them thoroughly.
as and
food remnants can
To Next Page
Loading...