9
• Automatic power off
The WS1 transmitter will turn off automatically if it doesn’t detect any
input signal for 10 minutes� The receiver will turn off automatically at
10 minutes after the transmitter turns off�
• ID matching
The WS1 transmitter and receiver have already assigned unique
matched ID at the factory� If you want an another WS1 transmitter or
receiver to get paired, follow the following steps to reset ID matching�
(1) Turn off all the WS1 transmitter and receiver around you�
(2) Press and hold the power button
of the transmitter and receiver
you want to pair for more than 5 seconds�
(3) While you press and hold, the receiver LED
will blink red� When
the ID matching finishes, the receiver LED
will blink and light
green� (Press and hold till the ID matching has been done�)
To Next Page
Loading...
