FULL SUSPENSION BIKES
Note on 243 Loctite: Shake the bottle well before applying!
HARDWARE TORQUE SPEC. THREAD TREATMENT
Cable Ports (Ripley AF / Ripmo AF only) 2Nm Grease
Derailleur Hanger Bolt 5 Nm Grease
Downtube Rock Guard (Ripley / Ripmo only) 2 Nm Loctite 243
Forward Shock Mount Bolt 10 Nm Loctite 243
Lower Link 6mm Preload Bolts 2 Nm Loctite 243 on threads, grease on flange
Lower Link Pinch Bolts 10 Nm Loctite 243
Lower Shock to Clevis Bolt 20 Nm Ti anti-seize
Swingarm to Clevis Pivot Bolts 10 Nm Loctite 243
Rear Brake Caliper 6 Nm Loctite 243
Seat Binder 5 Nm Ti anti-seize
Upper Link Bolts 10 Nm Loctite 243
BUSHINGS
On all models, apply Slick Honey (grease) to all bushings during reassembly.
HEXLE REAR AXLE
There is not a numerical torque figure for the Hexle. We recommend
tightening the 5mm with your multi tool that you carry with you.
This way you’ll be able to remove it in case of a flat out on a ride.
TORQUE SPECS
FOR MORE IN-DEPTH INSTRUCTIONS DOWNLOAD THE FULL SET UP GUIDE AT: ibiscycles.com/support/set-up_guide/
Ibis Cycles | 2240 Delaware Avenue, Santa Cruz, California, 95060 | ibiscycles.com
To Previous Page
Loading...
Need help?
General