Resetting the Adapter Configuration
During POST, if the configuration information in the adapter
NVRAM, EEPROM, and hard disk drive does not match, an error
message appears. You can view each configuration to determine
which you want to use.
The Init/View/Synchronize Configuration menu enables you to
view or reset the following parameters:
Initialize Configuration restores the factory default settings,
and resets all functional, connected, hard disk drives to the
Ready (RDY) state.
View NVRAM Configuration displays the current configuration
settings for the adapter's NVRAM.
View EEPROM Configuration displays the current
configuration settings for the adapter's EEPROM.
View Hard Drive Configuration displays the current
configuration settings for the selected hard disk drive that is in
the online (ONL) or rebuild (RBL) state.
View Change List displays the configuration conflicts that the
ServeRAID adapter reported since the last time the server was
powered on or restarted. For more information, see “Viewing
Configuration Changes” on page 119.
To initialize, reset, or view the adapter configuration:
1. Start the ServeRAID configuration program (see “Starting the
ServeRAID Configuration Program” on page 86).
2. Select Advanced Functions from the Main Menu.
3. Select Init/View/Synchronize Config.
118 PC Server 520 User's Handbook for PCI/EISA
To Next Page
Loading...
