Using the Mini-Configuration Program
Using the Mini-Configuration Program
The Mini-Configuration program is a quick way to display the
adapter settings, and to perform a limited set of the configuration
functions without using the IBM PC ServeRAID Configuration
Diskette.
To access the ServeRAID adapter Mini-Configuration program:
1. Turn on the server, or, if the system is on, press Ctrl+Alt+Del.
2. Press Ctrl+I immediately when the Mini-Configuration prompt
appears on the screen.
3. Press Enter.
If you have more than one ServeRAID adapter installed, you
will get an adapter selection screen; otherwise, the Main Menu
appears.
View Adapter Status displays the current status of the
ServeRAID adapter. (See “Viewing the Adapter Status” on
page 134 for information.)
View Configuration shows the current configuration
information for the ServeRAID adapter. (See “Viewing
Configuration Information” on page 135 for information.)
Advanced Functions resets the adapter, initializes the
configuration, and imports the configuration from drives.
(See “Using Advanced Configuration Functions” on
page 135 for information.)
4. Select a menu item, press the number of the item or use the Up
Arrow (↑) key or Down Arrow (↓) key to highlight the item,
then press Enter.
5. Follow the instructions on the screen.
6. Select Exit to leave the Main Menu.
Chapter 3. Configuring the Disk Array 133
To Next Page
Loading...
