Connecting External Options
What to do next?
If you installed options during the initial setup of your server,
go to Chapter 2, “Installing Software” on page 21 to complete
the installation procedure. Then return here.
If you installed hot-swap drives, you might need to update your
server configuration parameters.
If your server is a disk-array model, go to Chapter 3,
“Configuring the Disk Array” on page 77 to see if you need to
update your RAID configuration information; then, go to
Chapter 6, “Configuring Your Server” on page 279 for
additional details about configuration.
If your server is a non-disk-array model, go to Chapter 6,
“Configuring Your Server” on page 279 to see if you need to
configure your server.
If you removed memory modules or internal drives, you must
run the Setup program. See “Using the Setup Program” on
page 281 for instructions.
If you installed or removed an ISA or EISA adapter, you must
run the EISA Configuration program. See Chapter 6,
“Configuring Your Server” on page 279 for instructions.
Device drivers to install? (The instructions that come with the
option will tell you if device drivers are required and how to
install them.) If you do not need to install any device drivers or
configure the system, your server is ready to use.
Chapter 5. Installing Options 277
To Next Page