Setup Program
Recording and Restoring Default Settings
If you have a printer attached to your server, you can use the Print
Screen key to print the configuration settings. The default settings
are helpful when you install additional options, or if you need to
have your system serviced. Also, record the new settings each time
that you make changes. Be sure to record the current configuration
settings in “Installed Device Records” on page 378. You can restore
default settings easily by using the Setup program.
To restore default settings:
1. Turn on the server.
2. Press F2 to enter the Setup program.
3. Press F9 to restore the default settings.
4. Select Exit from the menu bar.
5. Select Save Changes and Exit.
Setting Passwords
To control access to your server, you can implement several of the
security measures described in your User's Reference, including
password protection. Two types of passwords are available with
the PC Server 520. These are the supervisor and user passwords.
To set these passwords and other security features, select the
Security menu bar from the Setup program and follow the
instructions on the screen.
Note: The default values for all security-related data fields are
given in Table 3 on page 379.
After you set the supervisor password, Enter password appears on
the screen each time that you attempt to access the Setup program.
After you set the user password, Enter password appears on the
screen each time you attempt to access your operating system. (The
passwords do not appear on the screen as you type them.) If you
enter the wrong password, Invalid password appears on the screen,
and Enter password appears again. After three incorrect attempts,
you must turn off the server and start again.
Chapter 6. Configuring Your Server 283
To Next Page