Installing Additional Test Programs
to contain the QA files), that directory must be listed in
the PATH= section of the AUTOEXEC.BAT.
4. You can use a .CFG file other than USERDIAG.CFG if
you use the command line “USRCONFIG=filename,” when
running the diagnostic programs. For example, you
might use: QAPLPRO /USRCONFIG=MYTESTS.CFG.
USERDIAG.CFG Example
An example USERDIAG.CFG file might look like the following:
Note: You can have more than one command-line parameter for
any given test.
When you view these tests on the Test Group window for the User
Diag test group, they appear as follows:
(♦) 9600 Baud 5 Line Modem
(♦) Generic 1
(♦) Generic 2
(♦) CMD 1
(♦) CMD 2
(♦) CMD 3
The diagnostic program automatically assigns a test number to each
test. The test numbers start at 201 and continue upward as needed.
The numbers for the tests listed above are as follows:
202 9600 Baud 5 Line Modem
203 Generic 1
204 Generic 2
205 CMD 1
206 CMD 2
Program Name Test Description Command-Line
Parameter
BBSMODEM.EXE; 9600 Baud 5 Line
Modem;
5
TEST1.EXE; Generic 1;
TEST2.EXE; Generic 2;
TESTALL.EXE; CMD 1; 1
TESTALL.EXE; CMD 2; 2
TESTALL.EXE; CMD 3; 3
Chapter 7. Solving Problems
361
To Next Page