backplane (continued)
connections
to one adapter (disk-array
model) 227
to two adapters (disk-array
model) 227
description 200
installing
bank D 225
bank E 235
jumper
bank C 200, 251
bank D 200, 251
bank E 200, 251
bad stripes 134
bank mapping 132, 386
banks
for hard disk drives
See bays
Basic Input/Output System (BIOS)
See also the User's Reference
upgrading 3
battery-backed clock 3
Bay Number 85
Bay/Array selection list 84
bays
See also the User's Reference
B
installing a drive in 207
non-hot-swap drive 205
removing a drive from 242
bank C
installing a drive in 216
removing a drive from 245
setting backplane
address 200, 251
bank D
backplane requirements 200,
222
installing a drive in 221
power-supply
requirements 200, 222
bays (continued)
bank D (continued)
removing a drive from 245
setting backplane
address 200, 251
bank E
backplane requirements 200,
233
installing a drive in 233
power-supply
requirements 200, 233
removing a drive from 245
SCSI-2 adapter
requirements 233
setting backplane
address 200, 251
drive types and sizes 200
expansion 3, 8, 199
general information
installing drives 200, 205
preinstallation steps 205
removing drives 241
identification 199, 383
internal drive locations 381
locations 199, 383
number and SCSI ID 253
beep codes, POST 308
before you begin 9, 159
bezel
See cover plates
bind command 45
blank screen 351
blocked logical drive 110, 116
bolt-down capability 3
boot
CD-ROM drive 304
password 286
sector, write-protecting 282, 286
sequence 284, 287, 379
Index 391
To Next Page