1.4 Setting Up Your Computer
Set up your computer as follows.
1. Open the left compartment cover in order of 1 and 2 .
PICTURE 15
2. Connect the numeric keypad connector in order of 1 and 2 . Open
the cover of the numeric keypad 3 .
PICTURE 16
3. Open the center compartment cover in order of 1 and 2 .
PICTURE 17
4. Write the machine model and serial numbers 1 on page NOTICES.
PICTURE 18
5. Insert the Rechargeable Battery into the center compartment by tilting
it to clear the latch 1 ; lower the battery and press it in until it
clicks into place.
PICTURE 19
6. Close the center compartment cover.
PICTURE 20
7. Plug the AC Adapter into the computer 1 . Plug the power cord into
the AC Adapter 2 ; plug the other end into a properly grounded
electrical outlet 3 .
PICTURE 21
8. Push in the release buttons 1 and lift to raise the display 2 .
PICTURE 22
9. Adjust the display angle for your viewing comfort by moving it back
and forth.
PICTURE 23
10. Set both Contrast 1 and Brightness 2 Controls to their middle
position.
PICTURE 24
11. Gather the following diskettes in one place.
# The Reference Diskette Version 1.01 or later
# A blank diskette whose storage capacity is 2MB. It has the
# letters HD 1 , is usually labeled 2.0MB capacity 2 and has two
# square cutouts 3 . Ensure that it is write-enabled by sliding
# the switch 4 up.
#PICTURE 25
12. Insert the Reference Diskette, with the label facing up and
metal-shutter end first, into the drive. Make sure the diskette
clicks into place.
PICTURE 26
PS/2 Model L40 SX Quick Reference
Setting Up Your Computer
¦ Copyright IBM Corp. 1991
1.4 - 1
To Next Page
Loading...
Need help?
General