i At the end of formatting the message Format Complete Successful is
briefly displayed. Follow the prompts to return to the System
Management Services menu. When it is done return to Step 23.
25 Select 4. Utilities, the System Management Utilities is displayed.
26 Reload the firmware to the hard disk (see “Updating System Firmware” on
page 5-16). When it is done continue with the next Step.
27 Restore the operational software on the new hard disk (see “Restoring the
Image Code of the Multiaccess Enclosure Hard Disk” on page 5-30).
28 Activate the configuration (refer to “Activate MAE Configuration Via CCM” on
page E-14).
29 Notify the network administrator that you are finished repairing the
Multiaccess Enclosure.
30 Go to “CE Leaving Procedure” on page 5-60.
Chapter 4. Multiaccess Enclosure FRU Exchange 4-31
To Next Page
Loading...
