Figure 85. Installing a drive in a system
Important: Ensure that the drive is fully seated and is all the way into the system.
c) Repeat “13.a” on page 84 and “13.b” on page 84 for the other front drives.
14. Replace the internal drive trays, if present:
a) Lower the drive tray into the system.
The bottoms of the trays have a hook that slides into a support. Ensure that hook slides under the
edge of the support. See the following gure.
Removing and replacing the system backplane in the 5105-22E, 9008-22L, 9009-22A, 9009-22G, 9223-22H,
or 9223-22S 85
To Next Page
Loading...
Need help?
General
