Attention:
v For reliable operation do not use Ground Fault Circuit Interrupter (GFCI), Earth
Leakage Circuit Breaker (ELCB), or Residual Current Circuit Breaker (RCCB)
type circuit breakers with the DS8880. The DS8880 is certified for safe operation
and compliant with IEC, EN, UL, and CSA 60950-1 standards. If local electrical
practice requires leakage detection circuit breakers, they must be rated at
minimum to 300 mA or larger to reduce the risk of outage due to spurious
actuation.
v Do not exceed the wire rating of the facility and ensure that separate protected
branch circuits are used for each cord in planning for redundancy.
Table 79. DS8880 power cords
Power cord feature
code
Power cord description
6
Inline connector Receptacle Wire gauge
1062
1, 2, 3, 4, 5
Single-phase power cord, 200V
- 240V, 60A, IEC 60309 3-pin
customer connector IEC'309
service ready plug for United
States, Canada, Latin America,
Japan, and Taiwan (EMEA and
other regions can optionally
order)
HBL360C6W, Pin and
Sleeve Connector, IEC
60309, 2P3W
HBL360R6W, ac
Receptacle, IEC
60309, 2P3W
10 mm² (7
AWG)
1063
2, 3, 4
Single-phase power cord, 200V
- 240V, 63A, no connector
(pre-stripped wires, termination
ready for EMEA (except Japan),
hard-wired, or uses client
provided customer
connector/plug as regionally
allowed)
Not applicable Not applicable 10 mm² (7
AWG)
1086
1, 4, 5
Three-phase WYE (3ØY)
voltage (five-wire 3+N+PE),
380-415V~ (nominal line-to-line
(LL)), 30 A, IEC 60309 5-pin
customer connector IEC'309
service ready plug, for EMEA
(other regions under approved
circumstances, such as United
States, Canada, Latin America,
Japan, and Taiwan can
optionally order)
HBL530C6V02, Pin
and Sleeve Connector,
IEC 60309, 4P5W
HBL530R6V02, AC
Receptacle, IEC
60309, 4P5W
6 mm² (10
AWG)
1087
1, 4, 5
Three-phase Delta (3Ø∆)
voltage (four-wire 3+PE
(Protective Earth Ground)),
200-240V, 30 A, IEC 60309 4-pin
customer connector with
IEC'309 service ready plug, for
United States, Canada, Latin
America, Japan, and Taiwan
(EMEA and other regions can
optionally order)
HBL430C9W, Pin and
Sleeve Connector, IEC
309, 3P4W
HBL430C9W, AC
Receptacle, IEC
60309, 3P4W
6 mm² (10
AWG)
Chapter 6. Delivery and installation requirements 159
To Next Page
Loading...
Need help?
General