IBM Flex System FC5022 - Page 24

14 IBM Flex System FC5022 2-Port 16Gb FC Adapter User’s Guide
Installing the device drivers, utilities, and HCM
2
• libXau-1.0.5-1.el6.i686.rpm
• libxcb-1.5-1.el6.i686.rpm
• libX11-1.3-2.el6.i686.rpm
• libXext-1.1-2.el6.i686.rpm
• libXi-1.3-2.el6.i686.rpm
• libXtst-1.0.99.2-3.el6.i686.rpm
Installing adapter software using BASI
Use these steps to install software using the GUI-based BASI application. Download the appropriate
1. Download the appropriate installer for your host’s operating system from
www.brocade.com/adapters-ibm-flex. Following are the programs for Windows and Linux:
• Windows
brocade_adapter_software_installer_windows_<version>.exe
• Linux
brocade_adapter_software_installer_linux_<platform>_
<version>.bin
2. Execute the appropriate Brocade Adapter Software Installer program (.exe or .bin file) that you
downloaded in the previous step.
A progress bar displays as files are extracted.
When all files are extracted, a Brocade Adapter Software title screen displays.
3. When the Brocade Adapter Software Installer Introduction screen displays read the
recommendations and instructions, then click Next.
4. When the License Agreement screen displays, select I accept the terms of the License
Agreement, then click Next to continue.
5. If a backup directory exists for previously installed software, a “Found Backed up data” message
displays prompting you to restore old configurations. Select either to restore or not to restore and
continue installation. If this message does not display, go on to step 6.
6. If a screen displays listing existing software components already installed on your system, select
one of the following options, click Continue, then skip to step step 10. If this message does not
display, go on to step 7.
• Install with existing configuration. The installer compares each configured property and
keeps the original value if different than the default value.
• Install with default configuration. The installer upgrades the software and loads with default
configurations.
NOTE
Existing versions of the software components will be overwritten with the current versions you
are installing if you continue.
7. If a message displays prompting you to close HCM, close the application if it is running, and then
click OK.
The Choose Install Set screen displays.