Note: For more information on the Verify Communications command (VFYCMN), see Verification
Procedures in the iSeries Service Functions
information.
b. On the next display, enter the line description name for the communications line that has the
remote power-on cable attached.
c. Select Cable test from the display that shows a list of tests that can be performed on a
communications line.
d. Follow all instructions (such as run problem analysis or attach the wrap connector).
Did you find the communications problem using the above procedure?
v No: Continue with the next step.
v Yes: Perform the following:
a. Exchange the failing item indicated (see Remove and replace procedures).
b. Verify that an IPL from a remote location completes successfully by going to step 5 (See page
24).
10. Find an entry in the Service Action Log that matches the time, SRC, and/or resource that compares
to the reported problem.
a. On the command line, enter the Start System Service Tools command (STRSST).
If you cannot get to SST, select DST (see Accessing Dedicated Service Tools in the iSeries
Service Functions
).
Note: Do not IPL the system to get to DST.
b. On the Start Service Tools Sign On display, type in a User ID with QSRV authority and Password.
c. Select Start a Service Tool —> Hardware Service Manager —> Work with service action log.
d. On the Select Timeframe display, change the From: Date and Time to a date and time prior to
when the customer reported having the problem.
e. Find an entry that matches one or more conditions of the problem:
1) SRC
2) Resource
3) Time
4) FRU list (choose Display the failing item information to display the FRU list).
Notes:
a. All entries in the service action log represent problems that require a service action. It may be
necessary to handle any problem in the log even if it does not match the original problem
symptom.
b. The information displayed in the date and time fields are the time and date for the first occurrence
of the specific system reference code (SRC) for the resource displayed during the time range
selected.
Did you find an entry in the Service Action Log?
v Yes: Was the entry isolated (is there a Y in the Isolated column)?
– Yes: Go to step 12 (See page 26).
– No: Go to System Reference Codes and use the SRC indicated in the log.
This
ends the procedure.
v No: Continue with the next step.
11.
Find an entry in the Product Activity Log that matches the time, SRC, and/or resource that compares
to the reported problem (see “Use the product activity log” on page 9).
Did you find an entry in the Product Activity Log?
v Yes: Continue with the next step.
v No: Exchange the following parts one at a time (see Remove and replace procedures).
Analyze hardware problems 25
To Next Page
Loading...
Need help?
General