Need help?Do you have a question about the IBM iSeries Series and is the answer not in the manual?
Gateway through which all service actions should be performed. Guides problem diagnosis.
Table to help start analyzing problems that occur during the Initial Program Load (IPL).
Guidance for analyzing problems that occur intermittently and are difficult to reproduce.
Table to help begin analyzing power problems.
Procedures to identify and isolate problems, covering various types like Bus, Communications, Disk, and Intermittent PIPs.
For use by authorized service providers. LIC detected an IOP programming problem.
For use by authorized service providers. DST found a permanent program error, or a hardware failure.
For use by authorized service providers. IPL service function ended due to disconnected status or lost communications.
For use by authorized service providers. System detected a problem communicating with a specific I/O processor.
For use by authorized service providers. Licensed Internal Code detected an operating system program problem.
For use by authorized service providers. Isolates system STARTUP failures in initial program load (IPL) mode.
Isolates failing devices identified by FI codes FI01105, FI01106, FI01107.
Isolates problems when two or more devices are missing from a disk array.
Isolates tape unit power problems.
To Next Page
General