Reference Code Description/Action Perform all actions before exchanging Failing Items Failing Item
69C6 Abnormal or unexpected HSL OptiConnect disconnection from a remote
system or partition.
The local system or partition disconnected from a remote system or
partition due to an unexpected event or failure. The problem is most likely
with the remote system or partition. Intervention at the remote system is
most likely required. Examine both the local and remote HSL
Opticonnected systems or partitions for problems on this HSL loop.
Possible reasons include: A fatal error in software or hardware in the
remote system or partition or a power failure in the remote system.
If there was not a complete HSL loop before this error occurred then a
failure or power down in an HSL component between the local system or
partition and the remote system or partition could have caused this error.
Check for a problem with: an HSL cable, HSL I/O bridge or a power
problem in an expansion I/O tower or unit on this loop.
Examine the Service Action Log (SAL) on the local system or partition for
HSL failures on the same HSL loop at approximately the same time this
error occurred.
Examine the remote system or partition for problems. If the remote system
or partition is powered on and IPL’d then examine the Service Action Log
(SAL) on the remote system or partition for problems on the same HSL
loop at approximately the same time this error occurred.
Correct any problems you find with the remote and local systems or
partitions that happened at approximately the same time and involve HSL
Opticonnect or HSL loop components or Network Interface Controllers.
When the remote system is IPL’d it will automatically reconnect with this
system or partition.
If there are no problems with the remote system or partition and there are
no problems with the local system or partition then collect all the Product
Activity Log information for this failure on both systems. Be sure to record
all words in the SRC. Contact your next level of support.
REM_SYS
B6xx (including A6xx)
290
iSeries: iSeries 270, 800, 810, 820, 825, 830, 840, 870, 890, SB2, and SB3 Analyze Hardware Problems (System Reference
Codes)
To Next Page
Loading...
Need help?
General