IBM iSeries 820 Analyze Hardware Problems (System Reference Codes

Reference Code Description/Action Perform all actions before exchanging Failing Items Failing Item
2333 Power Supply P03 ID is Invalid PWRSPLY
SPNLCRD
2334 Power Supply P04 ID is Invalid PWRSPLY
SPNLCRD
2400 to 2402 UPS Enable/Disable Failure UPSUNIT
SPNLCRD
2403 UPS CPM Failure UPSUNIT
SPNLCRD
2404 UPS Battery Failure BATRY
UPSUNIT
2405 UPS Unit Failure UPSUNIT
SPNLCRD
2406 to 2407 UPS Enable/Disable Failure UPSUNIT
SPNLCRD
2410 to 2411 UPS Test Failure UPSUNIT
SPNLCRD
2413 UPS Interface Failure UPSUNIT
SPNLCRD
2600 Power Good Fault PGDPART
TWRCARD
PWRSPLY
2601 to 2604 Power Good Fault PGDPART
TWRCARD
2610 Processor/Memory Card not installed PWRSPLY
TWRCARD
2611 Processor Regulator fault PWRREG
TWRCARD
2612 Optical Converter 5V Fault
The SPCN detected a fault on the SPCN card optical converter 5V.
CBLALL
TWRCARD
2613 Configuration Requires 200V Input
Configuration now requires 200V AC power.
CBLALL
300E EPO Circuit Fault
The ac module installed in the 9406 Expansion Unit (FC 504x) detected a
fault in the UEPO signal. The signal was active and the incoming ac
voltage was still present.
TWRCARD
21F9362
21F5680
302B PCC Overcurrent
The power control compartment is causing an over current condition in the
9406 Expansion Unit power system.
Exchange the ac module and the SPCN port cable at the same time.
TWRCARD
21F5680
21F9631
21F9362
3100 I2C Bus Controller Communication fault I2CBUS
TWRCARD
3101 I2C Bus 1 Communication fault I2CBUS
TWRCARD
3102 I2C Bus 2 Communication fault I2CBUS
TWRCARD
1xxx
32
iSeries: iSeries 270, 800, 810, 820, 825, 830, 840, 870, 890, SB2, and SB3 Analyze Hardware Problems (System Reference Codes)

IBM iSeries 820 Specifications

General

Brand	IBM
Model	iSeries 820
Category	Server
Language	English