EasyManuals Logo

IBM iSeries 820 Analyze Hardware Problems (System Reference Codes

IBM iSeries 820
306 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #67 background imageLoading...
Page #67 background image
Reference Code Description/Action Perform all actions before exchanging Failing Items Failing Item
9026 Battery Power Unit is reporting a low charge.
The battery power unit is not charged enough to run a test.
No action required. This reference code is logged for information only.
9027 Battery Power Unit is defective.
No action required. This reference code is logged for information only.
9028 SPCN Licensed Internal Code is not valid.
The Licensed Internal Code in the primary node is not valid. The code will
be reloaded.
No action required. This reference code is logged for error analysis only.
9029 SPCN VPD Damaged
The VPD record in the EEPROM has bad data.
Exchange the failing items for the node reporting the failure.
TWRCARD
902C Battery Power Unit test was aborted.
The battery power unit test was aborted.
No action required. This reference code is logged for information only.
902D Addressed frame is not in SPCN configuration table.
The addressed frame is not in the SPCN configuration table.
No action required. This reference code is logged for information only.
9031 Frame-to-Frame Communications Failure
The SPCN detected a BCC error on a transmission from another frame. The
transmission is attempted again.
No action required. This reference code is logged for error analysis only.
9032 SPCN Communications Failure, unit to rack.
The frame detected a BCC error on a transmission from a secondary node
to the frame. The transmission is attempted again.
No action required. This reference code is logged for error analysis only.
9033 SPCN Communications Failure, rack to unit.
A secondary node detected a BCC error on a transmission from the frame.
The transmission is attempted again.
No action required. This reference code is logged for error analysis only.
9034 Unsupported Packet Size
The receiving node detected a packet exceeding 70 bytes. The frame can
also return this code if a secondary node returns more than 10 bytes to a
PAS command.
No action required. This reference code is logged for error analysis only.
1xxx
System Reference Codes 63

Table of Contents

Other manuals for IBM iSeries 820

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM iSeries 820 and is the answer not in the manual?

IBM iSeries 820 Specifications

General IconGeneral
BrandIBM
ModeliSeries 820
CategoryServer
LanguageEnglish

Related product manuals