IBM Nortel Networks L2/3 - Page 158

144 Nortel Networks L2/3 Ethernet Switch Module for IBM Eserver BladeCenter
configure vlan "VLAN10" ipaddress 10.10.0.247 255.255.255.0
configure vlan "VLAN10" add port 1 tagged
configure vlan "VLAN10" add port 11 tagged
configure vlan "VLAN10" add port 23 tagged
#
# Config information for VLAN VLAN20.
configure vlan "VLAN20" tag 20 # VLAN-ID=0x14 Global Tag 5
configure stpd s0 add vlan "VLAN20"
configure vlan "VLAN20" qosprofile "QP1"
configure vlan "VLAN20" ipaddress 10.20.0.247 255.255.255.0
configure vlan "VLAN20" add port 1 tagged
configure vlan "VLAN20" add port 11 tagged
configure vlan "VLAN20" add port 23 tagged
#
# Config information for VLAN VLAN99.
configure vlan "VLAN99" tag 99 # VLAN-ID=0x63 Global Tag 6
configure stpd s0 add vlan "VLAN99"
configure vlan "VLAN99" qosprofile "QP1"
configure vlan "VLAN99" ipaddress 10.99.0.247 255.255.255.0
configure vlan "VLAN99" add port 1 tagged
configure vlan "VLAN99" add port 11 tagged
configure vlan "VLAN99" add port 23 tagged
# Boot information
use image primary
#Configuration Information
use configuration primary
delete account user
configure account admin encrypted
452eN2$1bS/.EI6vFqiY/TcN8wIo1
452eN2$1bS/.EI6vFqiY/TcN8wIo1
create account user "user" encrypted "yN/eN2$zxKAyFhkr/1cfugaePE/f0"
enable telnet access-profile none port 23
#
# Banner Configuration
#
# omitted
# SNMP Configuration
# omitted
# Load Sharing Configuration - create two static multi-link trunks each w/ 2 ports
enable sharing 1 grouping 1,2
enable sharing 11 grouping 11,12
# Ports Configuration
# omitted
# Spanning tree information
configure stpd s0 tag 10
configure stpd s0 mode dot1d # dot1w is also available for rapid STP
configure stpd s0 port link-type broadcast 1
# identical lines for remaining ports omitted.
enable stpd s0
# MAC FDB configuration and static entries
configure fdb agingtime 300
configure ipfdb agingtime 0