IBM Nortel Networks L2/3 - Page 160

146 Nortel Networks L2/3 Ethernet Switch Module for IBM Eserver BladeCenter
configure ip-mtu 1500 vlan "VLAN99"
# Global IP settings.
configure irdp 450 600 1800 0
configure irdp broadcast
disable icmp useredirects
disable iproute sharing
configure ipfdb route-add clear-all
disable bootprelay
configure ip-down-vlan-action forward
#
# IP ARP Configuration
configure iparp timeout 20
configure iparp max-entries 4096
configure iparp max-pending-entries 256
enable iparp checking
enable iparp refresh
#
# IP Route Configuration
configure iproute add default 9.42.171.3 1
# Multicast configuration
# omitted
# RIP interface configuration
configure rip delete vlan "Default"
configure rip txmode v2only vlan "Default"
configure rip rxmode any vlan "Default"
configure rip vlan "Default" cost 1
configure rip vlan "Default" trusted-gateway None
configure rip vlan "Default" import-filter None
configure rip vlan "Default" export-filter None
configure rip add vlan "VLAN99"
configure rip txmode v2only vlan "VLAN99"
configure rip rxmode any vlan "VLAN99"
configure rip vlan "VLAN99" cost 1
configure rip vlan "VLAN99" trusted-gateway None
configure rip vlan "VLAN99" import-filter None
configure rip vlan "VLAN99" export-filter None
configure rip add vlan "VLAN20"
configure rip txmode v2only vlan "VLAN20"
configure rip rxmode any vlan "VLAN20"
configure rip vlan "VLAN20" cost 1
configure rip vlan "VLAN20" trusted-gateway None
configure rip vlan "VLAN20" import-filter None
configure rip vlan "VLAN20" export-filter None
configure rip add vlan "VLAN10"
configure rip txmode v2only vlan "VLAN10"
configure rip rxmode any vlan "VLAN10"
configure rip vlan "VLAN10" cost 1
configure rip vlan "VLAN10" trusted-gateway None
configure rip vlan "VLAN10" import-filter None
configure rip vlan "VLAN10" export-filter None
# RIP global parameter configuration
disable rip aggregation
enable rip splithorizon
enable rip poisonreverse
enable rip triggerupdate
disable rip export static
disable rip export ospf-intra