IBM PC 300GL

12. Move the jumper back to its normal position (pins 1 and 2).
13. Replace the computer cover.
14. Plug in the power cord.
After clearing CMOS memory, you must reconfigure the computer. After
reassembling the computer, use the Configuration/Setup Utility program to
reset the date and time, reset any passwords, and reconfigure the computer.
Other settings in the Configuration/Setup Utility
program
The information in this section includes instructions for changing other
settings in the Configuration/Setup Utility, such as the keyboard speed, the
startup sequence, remote administration, and power management.
Changing keyboard speed
You can change the speed at which the keyboard responds when you hold
down a key. This setting can be found under Start Options in the
Configuration/Setup Utility program. The default typematic rate is 30
characters per second (fast rate).
Setting the startup sequence
Your computer can be started from several devices including the hard disk
drive, diskette drive, CD-ROM drive, or from the network. The startup
program looks for these devices in a selected sequence. You can use
Configuration/Setup Utility to select the startup sequence.
To set the startup sequence:
1. Start the Configuration/Setup Utility program (see “Starting and using
the Configuration/Setup Utility program” on page 29).
2. Select Start Options and press Enter.
3. Select Startup Sequence from the Start Options menu and press Enter.
4. Select First Startup Device and press Enter.
5. Use the arrow keys to make your selection and press Enter.
6. If necessary, repeat the above steps for Second Startup Device, Third
Startup Device, and Fourth Startup Device.
7. If Automatic Power On Startup Sequence is Enabled, select the
sequence and devices from the choices provided.
38 PC 300GL User Guide